![sp flash tool error 8038 sp flash tool error 8038](https://ellas-cookies.com/images/kompyuteri/flashtool-oshibki-rasshifrovka-reshenie-problemi-sposobi-i-rekomendacii_7.jpg)
![sp flash tool error 8038 sp flash tool error 8038](https://www.thekonsulthub.com/ezoimgfmt/i2.wp.com/www.thekonsulthub.com/wp-content/uploads/2020/04/SP_Flash_tool_brom_error_4008_fix_q3h70g.png)
![sp flash tool error 8038 sp flash tool error 8038](https://i.ytimg.com/vi/usdM_lJ5IsY/maxresdefault.jpg)
In this state, the Flash Tool does not close the COM port, and trying to restart any operation by reconnecting the device will cause an error. Error Message Meaning: SP Flash Tool could not write to certain. Message: Error 8038 Android download pmt is ready and layout has been. SP Flash Error Message: ERROR 8038 Android Download PMT is ready and layout has been changed. When after the red strip pass to 100% as a result of the firmware, Operation buttons are again available for clicking, but no error message, no green circle, this error appears, or similar to it, the code of which is 1013. If youre certain it wasnt, try a higher version of SP Flash tool. After a while I get the message BROM ERROR: SCOMPORTOPENFAIL (1013) (COM) Failed to open COM 4 (HINT): Possible reason:1. The port was visible, it was selected in the Flash Tool settings, the program recorded it in the INI file, after which the system was rebooted with the port disabled, and immediately launched the Flash Tool without selecting the port. I have downloaded the SP Flash tools and drivers but no red bar is loading up in Smart Phone Flash Tool (Runtime Trace Mode). Theoretically, it can occur in the USB UART mode. Right-click flashtool. If the USB port of the computer is faulty, then it is necessary to puncture the cable to another port.
#SP FLASH TOOL ERROR 8038 INSTALL#
I'm trying to install CWM Recovery into Fly IQ444 Quatro (it is the same, as Gionee Dream D1/GN878), using. The problem can be in the USB cable, in this case, replace the cable. Hi, guys I have a problem with SP Flash Tool. In this case, you will not see the equipment on which the PRELOADER drivers are placed. Even if the COM port is virtual, and the physical USB. For example, an error may occur if COM ports are disabled in the BIOS.